Carriage dimensions: 3200 x 400 mm
Table dimensions: 670 x 1250 mm
Squaring frame dimensions: 640 x 1400 mm
Saw blade diameter/hole diameter without scoring blade: 550 x 30 mm
Saw blade diameter/hole diameter: 500 x 30 mm
Cutting height with Ø 500 x 550 mm blade at 90° (with Ø 550 mm blade in minimum position, it protrudes 25 mm from the table): 175 x 200 mm
Cutting height with Ø 500 x 550 mm blade at 45°: 120 x 140 mm
Scoring blade diameter/hole diameter: 125 x 20 mm
Scoring blade speed: 7500 rpm
Scoring motor power: 1 HP
Cutting width: mm 1250
Variable saw blade speeds controlled from the control panel from 2500 to 5000 rpm
Motor power: 7.5 HP
Machine weight: 1190 kg
CE MACHINE EQUIPMENT
Motorized blade tilt and lift unit controlled from the VK3 control panel:
Manual or automatic blade lift and tilt positioning
Saw blade speed selection (function linked to the blade diameter installed)
Encoder reading system
Automatic axis calibration
Scoring unit with independent motor. Sliding, height, and translation on linear guides. Pneumatic insertion. The scoring blade only lifts when the scoring motor is running.
Widia blade
CX 550 suspended blade guard
Table extensions
Angle cutting device
Lever-operated eccentric clamp
Inverter-controlled motor start and stop
Squaring frame with reference marks for squaring rod tilt
Large squaring frame jig sliding on recirculating ball bearings
2 extraction ports (1 x Ø 120 mm, 1 x Ø 100 mm)
ACCESSORIES UPON REQUEST
Motorized rip fence with movements controlled by the control panel with manual and automatic functions and the possibility of incremental movements: encoder reading system; automatic change of the height relative to the fence position, profile positioned high or low; automatic axis calibration; Automatic recovery of the height between parallel cutting and blade tilt (V8 or V10 control panel required)
8" touchscreen control panel, model V8: automatic and semi-automatic functions; automatic recovery of the blade height when tilted (pendant panel required)
10" touchscreen control panel, model V10: automatic and semi-automatic functions; Automatic blade height adjustment when tilted (pendant panel required)
Automatic 2-axis adjustment of the scoring unit (V8 or V10 control panel required)
Fixed pendant control panel with joint
EASY squaring frame with automatic stop position compensation
Double-sided protractor for bevel cuts
Double-sided protractor for bevel cuts with electronic digital angle readout
10 HP motor
12 HP motor
15 HP motor
Squaring bar with 3 electronic digital readouts
Electronic digital readout on rip cut guide
Cutting width: 1500 mm
Carriage controls
Pneumatic pressure bar along the entire length of the carriage
2nd support frame on the carriage sliding on a floor-mounted rail
Table with stop for rip cut
Goniometer with measurement recovery
Laser (without panel option) (Wall-mounted)
Laser (pendant panel with joint required)
Software for connection to management software in compliance with Industry 4.0 regulations (V4C or V10 control panel required)
- Italy
- New
